The whole house
New supply lines run to every fixture, through walls, ceilings and crawl spaces that are opened and closed again. The plumber maps the route before any cutting starts.
Repiping and Water Line Replacement in Nampa
Pipes that leak again after each repair or lines that keep needing patches may be ready for new supply lines, either a section at a time or all the way through.
Two jobs fall under this heading, replacing the supply pipes inside the house and replacing the water line that feeds it.
Ways to repipe
One section
When only one run has failed, replacing just that run can be enough. The plumber checks the pipe on either side to see whether it is likely to follow.
A new water service line
Replacing the water service line is a job in its own right. The old pipe is taken out of service and a new one is joined to the house plumbing.
PEX or copper
PEX and copper both carry water well. PEX flexes around corners with fewer joints, while copper is rigid and soldered at each fitting, and the plumber weighs them against your walls and layout.
The permit rule for repiping
Repiping is piping work, so the City of Nampa Building Department’s permit rule for plumbing piping and drainage work applies to it, with its exceptions for repairs to leaks, broken fixtures and like emergency repairs.
What gets opened up
Running new lines means getting into the places where the old ones sit. Ask the plumber which walls, ceilings or floors will be opened, and how each opening gets closed up again.
A leak that turns out to be one bad run may not need a full repipe, and leak detection can confirm that, while water heater work connects to the same supply lines. The home page lists the rest.
Call for a free plumbing estimate
Call us to discuss your current issue and how we can assist you. The call is free and you get a free, personalized estimate with no obligation. We're here to help.
Call (855) 321-3426